Binding Tests; Function Button On The Room Unit, Room Sensor, Meteo Sensor, Radio Repeater And Radiator Control Actuator - Siemens Synco 900 Operating Instructions Manual

Binding tests

The binding tests on the individual devices are triggered by briefly
pressing the function button (located under the battery compartment
cover).
On the central apartment unit, every successful binding test is con-
firmed by 3 short acoustic signals. Also, the display shows an addi-
tional window with information about the test just made.
The additional window stays on the display until it is confirmed with
the Menu / ok button or the Esc button, or until it is replaced by the
new additional window next time the binding test is made.
During the binding tests, the LED on the individual devices is used for
indicating the batteries' capacity or, in the case of the radio repeater,
for indicating mains voltage (refer to page 64).
Binding tests can be triggered on the following types of de-
vices: Room unit, room temperature sensor, meteo sensor,
radio repeater, radiator control actuator, and heating circuit
actuator.
After the binding test, the radio repeater indicates telegram
traffic with an orange LED flashing for 2 hours.
Function button on the room unit, room sensor,
meteo sensor, radio repeater and radiator control
actuator
Room unit QAW910
LED
F
Room sensor QAA910, meteo sensor
QAC910, and radio repeater ERF910
LED
F
68/76
Building Technologies
HVAC Products
Radiator control actuator SSA955
LED
F
Synco 900 Operating Instructions
Maintenance
F = function button
LED = light emitting diode
CE1B2707en
19.07.2006