Wireless Settings - Wireless Basics - D-Link DVA-G3672B User Manual

Chapter 2 Configuration
To access Wireless Basics, point to the Wireless Settings on the left window and click Wireless Basics submenu, or click the
Wireless Basics button in the Wireless Settings window.
The two essential settings for wireless LAN operation are the
Wireless Network Name (SSID) and Wireless Channel. The
SSID (Service Set Identifier) is used to identify a group of
wireless LAN components. The SSID can be visible (broadcast)
or hidden (not broadcast).
Follow the instructions below to change basic wireless settings.
1. The Wireless LAN is enabled by default. To disable the
wireless interface, click to deselect the Enable Wireless
check box. If the wireless interface has been disabled,
click the Enable Wireless check box again to select it.
2. The Wireless Network Name (SSID) can be changed to
suit your wireless network. Remember that any wireless
device using the access point must have the same SSID
and use the same channel.
3. The Visibility Status is Visible by default. To disable
SSID Visibility Status, click the Invisible radio button.
4. Select a country where the Router is located in the
Country drop-down list.
5. The Wireless Channel may be changed to channels
that are available in your region. Channels available for
wireless LAN communication are subject to regional and
national regulation.
6. Select a wireless protocol in the 802.11 Mode drop-down
list.
7. Click Apply to save the settings.
D-Link DVA-G3672B User Manual
Wireless Settings – Wireless Basics
25