Coolant Level; Engine Coolant - HYOSUNG GT650 Owner's Manual

11. Install the engine oil filler plug.
CAUTION
Failure to use the correct oil can damage
your motorcycle.
Engine damage may occur if you use the
engine oil that does not meet Hyosung's
specifications.
Be sure to use the engine oil specified in
the FUEL, ENGINE OIL AND COOLANT
RECOMMENDATION section.
12. Start the engine and allow it idle for a
few minutes. Check to see that no the
engine oil is leaking from the oil filter
cap and drain plug.
13. Check the oil level according to Engine
Oil Level Check procedure.
CAUTION
Engine oil leaks from around the oil filter
cap or drain plug indicate incorrect
installation or the "O" ring / gasket dam-
age. If you find any leaks or are not sure
that the oil filter cap / drain plug has been
properly installed, have the motorcycle
inspected by your Hyosung dealer or
qualified mechanic.

ENGINE COOLANT

COOLANT LEVEL

The coolant should be kept between the
"F"(FULL) and "L"(LOW) level lines in the
reservoir tank at all times. Inspect the level
every time before riding while the motorcy-
cle vertically. If the coolant is found lower
than the "L" level line, add properly mixed
coolant in the following way :
If the reservoir tank is emptied, pour the
engine coolant to the reservoir tank and
radiator.
1. Wait for the engine to cool down before
checking or topping up coolant level.
2. Remove the front seat.
3. Remove the reservoir tank filler cap
4. Add properly mixed coolant through the
filler hole until it reaches the "F" line.
Refer to the FUEL, ENGINE OIL AND
COOLANT RECOMMENDATION section
(17 page).
50
.