TURN SIGNAL LAMP'S BULB
REPLACEMENT
1. Remove the lens by removing the
screw.
2. Pushing the bulb, turn it to the counter-
clockwise, and pull it out.
3. After stick in the new lamp, assemble the
lens.
CAUTION
Overtightening the screws may cause
the lens to crack.
BRAKE / TAIL LAMP'S BULB
REPLACEMENT
are LED (Light Emitting Diode) type.
If any abnormal condition are found,
replace the brake / tail lamp assembly.
LICENSE PLATE LAMP'S BULB
REPLACEMENT
1. Remove the lamp housing by unscrewing
the screw
2. Pull out the socket
housing.
3. Pull out the bulb at the socket.
4. Replace the new bulb.
5. To install the license plate lamp, reverse
the above sequence.
87 87
's brake / tail lamp
.
from the lamp