Montigo H38DF-PRC Installation, Operation & Maintenance Manual page 13

Section 3-3-2:
VENTING COMPONENTS
The following components and associated Montigo part num-
bers are available for installation of a Wall Mounted Termination.
Use only Montigo Vent Components. Use of non-Montigo parts
will void the warranty and may impede operation of the fireplace.
A - Termination
B - Stucco Kits
C - Flex Sections
D - Rigid
Sections
E - Elbows
Connection and installation of the vent components should
adhere to the following guidelines:
Use any combination of rigid and Flex pipe as required.
„
Flex sections may be stretched up to 50% of their total length
„
(e.g. a 24" section maybe stretched to 36").
Connect all vent sections using a minimum of three sheet metal
„
screws on the outer pipe flue..
Ensure the pipe ends male to female slide in a minimum of 1
„
1/2" of overlap.
Ensure all runs are supported with a minimum of 3 supports
„
per 10' of venting.
When hanging/ supporting venting, ensure that 1" clearance
„
is maintained on sides and bottom of vent runs and 2" above
horizontal vent runs to any combustible material.
Ensure when cutting sections of rigid pipe to maintain integrity
„
of internal supports.
Place the springs, supplied with the pipe kit, between the outer
„
and inner pipes to keep the pipes separate and avoid any
possible hot spots.
Montigo recommends the use of a flex section for the final pipe
„
connected directly to the fireplace offering greater flexibility of
installation and absorption of movement.
Part No. XG0211 - 080510
Installation
PTO-3 (3" Length)
PTO-3F (3" Length)
PTO-4 (3" Length)
PTO-4F (3" Length)
MSR (Stucco Frame)
BSR-4 (4" Brick Frame)
BSR-6 (6" Brick Frame)
MOSR (Stucco Can)
PFL- 1 (12" f/f Section)
PFL- 18 (18" f/f Section)
PFL- 2 (24" f/f Section)
PFL- 3 (36" f/f Section)
PFL- 4 (48" f/f Section)
PFL- 6 (72" f/f Section)
PXT- 5 (5" f/f Section)
PXT-10 (10" f/f Section)
PEXT- 1 (12" m/f Section)
PXT- 20 (20" f/f Section)
PEXT- 2 (24" m/f Section)
PEXT- 3 (36" m/f Section)
PEXT- 4 (48" m/f Section)
PEXT- 6 (72" m/f Section)
PEL- 90MM (m/m 90° Elbow)
PEL- 90FF (f/f 90° Elbow)
PEL- 90FM (f/m 90° Elbow)
PEL- 45FM (f/m 45° Elbow)
H(L)38DF-PRC Indoor Panorama Gas Fireplace
When penetrating a combustible ceiling, a ceiling firestop
„
must be used.
Montigo recommends that all exterior corners and joints be
„
sealed with exterior caulking however we encourage you to
consult your Building Envelope Engineer or Waterproofing
Consultant for further recommendations.
Page 13