Honda 2007 PILOT SECURITY SECTION Installation Instructions Manual page 5

15. On the inside of the upper steering column cover,
measure and mark the upper steering column
cover.
16. While wearing eye protection, center-punch the
5.5 mm BIT
UPPER STEERING
COLUMN COVER
FELT-TIP
PEN
MARK
CENTER LINE
mark; then drill a 5.5 mm hole through the upper
steering column cover. Remove all burrs with a
round file.
17. Route the terminal ends of the LED through the
hole you just drilled, and secure the LED with the
push nut. Install the push nut securely.
18. Using isopropyl alcohol, thoroughly clean the
UPPER STEERING
COLUMN COVER
PUSH NUT
(Note the installation direction.)
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
DRILL
PUNCH
30 mm
LED
LED
back of the upper steering column cover in the
area shown. Secure the LED harness to the upper
steering column cover with a cushion tape.
19. Get the 2-pin connector included in the kit. Firmly
CUSHION
TAPE
push the LED terminals into the 2-pin connector
until they click into position, then lower the lock.
NOTE:
It is important to insert the red and white wires as
shown for the LED to fanction.
20. Reinstall the upper steering column cover, then
3D08160T
2-PIN
CONNECTOR
secure the LED harness to the vehicle harness
with the wire tie.
21. Route the security system harness 2-pin
LED
HARNESS
All 33080-33238 (0607)
UPPER STEERING
COLUMN COVER
LED
HARNESS
Insert.
Lock.
WHITE WIRE
RED WIRE
UPPER STEERING
COLUMN COVER
WIRE TIE
3D08080T
3D08111T
5 of 7