Honda 2007 PILOT SECURITY SECTION Installation Instructions Manual page 4

8. Loosely install the flange bolt to the vehicle
bracket at the right side of the steering shaft.
HOLE
CORNER
CONTROL
UNIT
BRACKET
STEERING
SHAFT
9. Insert the control unit bracket onto the flange bolt.
Align the tab from control unit bracket to the
corner of the vehicle bracket, and tighten the
flange bolt.
10. Install the two wire ties with clip from the security
system harness to the holes in the steering
hanger beam.
11. Plug the security system harness 22-pin
connector into the security unit.
STEERING
HANGER BEAM
WIRE TIES
WITH CLIP
SECURITY
SYSTEM
CONTROL
UNIT
12. Reinstall the TPMS unit removed in step 6.
4 of 7
VEHICLE BRACKET
FLANGE BOLT
VEHICLE
BRACKET
FLANGE
BOLT
CONTROL
UNIT
BRACKET
TAB
4N17030Y
SECURITY
SYSTEM
HARNESS
22-PIN
CONNECTOR
SECURITY
SYSTEM
4N17040Y
HARNESS
All 33080-33238 (0607)
13. Below the steering hanger beam, locate the 14-pin
connector blue-taped to the vehicle harness, and
remove the blue tape to free the connector. Plug
the security system harness 14-pin connector into
the 14-pin connector you just freed.
14. Secure the security system harness to the
BLUE TAPE
VEHICLE
14-PIN
CONNECTOR
SECURITY
SYSTEM
HARNESS
14-PIN
CONNECTOR
vehicle harness with the two wire ties.
Installing the LED
WIRE TIE
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
STEERING
VEHICLE
HANGER BEAM
HARNESS
SECURITY
SYSTEM
HARNESS
3D08062T
VEHICLE
HARNESS
SECURITY
SYSTEM
HARNESS
3D08073T