Tools And Supplies Required; Installation - Honda 2007 PILOT SECURITY SECTION Installation Instructions Manual

TOOLS AND SUPPLIES REQUIRED

Phillips screwdriver
Flat-tip screwdriver
8 mm and 10 mm Combination wrenches
Ratchet
10 mm Socket
Diagonal cutters
Punch
Felt-tip pen
Isopropyl alcohol
Shop towel
Drill
3 mm, 5.5 mm and 8 mm Drill bits
Tape measure
Eye protection (face shield, safety goggles, etc.)
Illustration of Security System installed on the
Vehicle
SECURITY
UNIT
SECURITY SYSTEM
HARNESS
2 of 7
LED
3D08011T
MICROPHONE
All 33080-33238 (0607)

INSTALLATION

Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the driver's dashboard lower cover (one
self-tapping screw, three clips, and two hooks).
RETAINING
TABS (2)
SELF-TAPPING
CLIPS (3)
SCREW
4. Remove the switch cover (two retaining tabs).
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
SWITCH COVER
HOOK
DRIVER'S
DASHBOARD
LOWER COVER
3D08170T