Honda 2007 PILOT SECURITY SECTION Installation Instructions Manual page 6
Security system
Hide thumbs
Also See for 2007 PILOT SECURITY SECTION:
- Navigation manual (137 pages) ,
- Owner's manual (324 pages)
Advertisement
connector along the vehicle harness and plug it to
the LED harness 2-pin connector.
22. Insert the holder bracket onto the LED harness
HOLDER BRACKET
WIRE TIE WITH
CONNECTOR HOLDER
LED HARNESS
2-PIN CONNECTOR
SECURITY
SYSTEM
HARNESS
2-PIN
CONNECTOR
VEHICLE
WIRE TIE
HARNESS
SECURITY SYSTEM
HARNESS
3D08122T
2-pin connector and insert the wire tie with
connector holder into the holder bracket.
23. Secure the LED harness and the security system
harness to the vehicle harness with the wire tie
with connector holder and the wire tie.
24. Reinstall the lower steering column cover.
Installing the Microphone
25. Measure and mark the center of the switch cover
removed in step 4.
26. While wearing eye protection, center-punch the
DRILL
3 mm
8 mm BIT
CENTER LINE
PUNCH
SWITCH
COVER
FELT-TIP PEN
3D08092T
mark; then drill an 8 mm hole through the center-
punched mark. First drill a pilot hole with a 3 mm
bit, then finish with an 8 mm bit. Remove all burrs.
27. Route the microphone jack through the hole in the
switch cover and seat the microphone in the
switch cover.
28. Cut two EPT sealers in half. Wrap three of the
SWITCH COVER
MICROPHONE
MICROPHONE
JACK
SWITCH COVER
3D08101T
Page 6
Advertisement
