Datalogic QuickScan QS6500BT Quick Reference Manual page 10

8. Place the linear imager in the Base Station and verify the
charge LED is flashing. After five minutes, the scanner will
have sufficient charge to begin reading labels. A full charge
from depleted battery will take approximately 2 hours.
9. Press and hold the link button on the bottom of the Base
Station for three seconds. This will ensure that any other
imager link to the Base Station will be broken. Upon unlink-
ing, the Base Station will sound a short beep, followed by
two longer beeps, accompanied by a flashing amber LED.
10.Scan the bar code located on the label applied to the back
face of the Base Station. This will "link" the linear imager to
the Base Station. Upon successful link (which can take a few
seconds), the imager will sound a low-to-high pitched beep.
11
11.To verify scanning operation, point the linear imager at a bar
code and pull the trigger. The linear imager should emit a
beep indicating that the label has been scanned and transmit-
ted to the Base Station successfully.
The linear imager installation is complete.
NOTE
2
A momentary press of the link button can be used to later
verify a link between the imager and Base Station. A good
link is indicated by six short beeps. The Base Statioin notes
an unlinked situation by slowly flashing an amber LED.
10
TM
QuickScan QS6500BT