Table of Contents
Advertisement
(3) Quick-lock vise
The Model CD 14F is equipped with the quick lock vise ass'y that can securely fasten a workpiece just by
tilting the clutch toward vise (A) (to screw-fit the clutch) and turning the screw handle, and quickly release the
vise (A) just by tilting the clutch backward (to release the screw-fitted clutch). Thus the fastening time is
remarkably shortened.
(When fastening vise (A))
Time required for fastening a workpiece (from the state vises (A) and (B) are contacted to the state a workpiece
is securely fastened)
Workpiece material: SGPW 65A (76.3 mm in outer diameter)
Model
Maker
CD 14F
Hitachi
CC 14SC
U
(4) Stopper
The Model CD 14F is equipped with the stopper to cut workpieces at
the same length continuously. The stopper's cutting range is from
38 mm to 228 mm.
<How to use the stopper>
1. Loosen the hex. head socket screw and pull the holder.
2. Loosen the wing bolt and move the stopper to the desired position.
3. Press a workpiece against the stopper and cut it.
(5) Overload protector
The Model CD 14F is equipped with the overload protector that stops
the motor if an abnormal overload is applied to the tipped saw blade
to prevent the motor from being burnt. If this overload protector is
activated, release the trigger switch and remove the cause of trouble.
Wait several minutes until the Model CD 14F cools down, then press
the overload switch to restart the Model CD 14F.
(6) Dust box
The dust box collects cutting dust for ease of cleaning after cutting
operation. As a guide, remove cutting dust at intervals of about 20
times of cutting operation when the workpiece is SGPW65A pipe
(76.3 mm in dia., 4.2 mm in thickness).
Fig. 1
Fastening time
Quick lock vise
11 sec.
26 sec.
Screw vise
--- 3 ---
(When releasing vise (A))
Remarks
Fig. 2
Fig. 3
Fig. 4
Advertisement
Table of Contents
