Table of Contents
Advertisement
(3) Removal of the handle cover, hook, trigger switch, overload switch and switch handle:
Tools required:
14 mm wrench
(+) screwdriver
Nippers
Loosen the nut of the Overload Switch [44] and remove one Machine Screw M5 x 18 [48].
1
Remove the Machine Screw M5 x 23 [58], Machine Screw M5 x 30 [50] and Machine Screw M5 x 25 [51] then
2
remove the Handle Cover [52].
Disconnect the faston connector from the Overload Switch [44] and remove the Overload Switch [44].
3
Remove the internal wires from the Switch [61]. Remove the two Tapping Screws (W/Flange) D4 x 10 (Black)
[55] and the Switch [61].
Loosen the Protection Rubber [25] and remove the Machine Screw (W/SP. Washer) M5 x 16 [31], Cord Clamp
4
[30] and Machine Screw M5 x 8 [56]. Cut the internal wire of the Cord [23] that is crimped by the Wire
5
Connector [60] with nippers. Pull out the Cord [23].
Remove the two Machine Screws M5 x 18 [48] and the Switch Handle [62].
--- 15 ---
Advertisement
Table of Contents
