Metal Cutting Saw Model CD 7SA Handling instructions Note: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool.
c) Avoid accidental starting. Ensure the switch is in GENERAL SAFETY RULES the off position before plugging in. Carrying power tools with your finger on the WARNING! switch or plugging in power tools that have the Read all instructions switch on invites accidents. Failure to follow all instructions listed below may result in d) Remove any adjusting key or wrench before electric shock, fire and/or serious injury.
PRECAUTION Kickback is the result of saw misuse and/or incorrect Keep children and infirm persons away. operating procedures or conditions and can be avoided When not in use, tools should be stored out of reach of by taking proper precautions as given below. children and infirm persons.
For all other sawing, the lower guard should operate 8. Ensure that the retraction mechanism of the guard automatically. Model CD7SA is not designed or system operates correctly. intended to perform "plunge cuts" and "compound 9. Never operate the metal cutting saw with the saw cuts".
OPTIONAL ACCESSORIES (sold separately) Carbide tipped saw blade Outer Hole Thickness of Number Blade diameter diameter width saw blade of teeth 180 mm 20 mm 1.8 mm 1.5 mm 34 teeth For cutting soft steel materials 185 mm 20 mm 2.0 mm 1.6 mm 38 teeth...
Check to see whether the lower guard moves. functions. If for any reason the brake fails to CAUTION operate, please contact an Authorized Hitachi Do not fasten the lower guard permanently Service Center for repair. in one position. Make sure that it can move CAUTION smoothly.
SELECTING THE CORRECT TIPPED SAW BLADE FOR DIFFERENT MATERIALS In order to get the best performance from your metal cutting saw, it is important to select the correct type of tipped saw blade for the type of material to cut. Please use the blades best suited for cutting different thickness of different materials as shown below.
middle of cutting a work piece, pull the chip saw back with the blade still turning and after it is no longer in contact with the work piece material, then turn the power switch off. Workpiece Do not to try to cut the same work piece two times in the same location.
(3) While pushing in the lock lever, slowly unscrew the THROWING AWAY THE CUTTING DUST bolt using the box wrench provided. (4) Holding the spindle in position, turn the box wrench CAUTION: counter-clockwise and remove the bolt and the To prevent possible accidents, always turn the metal washer (B).
The cutting dust can then be thrown away without CAUTION spilling it. Repair, modification and inspection of Hitachi Power Tools must be carried out by a Hitachi Authorized Service Center. This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service Center when requesting repair or other maintenance.
Hitachi Koki Co., Ltd. Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99167511 F Printed in China...