Table of Contents
Advertisement
(5) Removal of the shaft, spring (A), dust box, bottom plate and wrench holder:
Tools required:
17 mm wrench (standard accessory)
2.5 mm wrench (hex. bar wrench)
(+) screwdriver
(-) screwdriver
Plastic hammer
Slender-nose pliers
1
Loosen the Nut M10 [115] and tighten the Bolt M10 x 60 [114]. Be careful that the Gear Case [29] falls
backward.
2
Loosen the Hex. Socket Set Screw [113] completely.
Lightly tap the Shaft [109] at the front with a plastic hammer to remove it. Use of a shaft 10 --- 20 mm in
3
diameter and 200 mm in length is recommended. At this time, support the Gear Case [29]. Spring (A) [119]
can be removed by removing the Shaft [109].
4
Remove each mounting screw of the Side Cover [132], Rubber Leg [136], Dust Box [120], Bottom Plate [140]
and Wrench Holder [117] to remove them from the Base [135].
5
Remove the Hex. Socket Hd. Bolt M8 x 40 [127] from the Base [135]. Remove the Retaining Ring for D12
Shaft [128] and pull out the Holder [143] from the Base [135].
--- 17 ---
Advertisement
Table of Contents
