ADEMCO security system User Manual page 40

UL NOTICE: This is a "Grade A" 'Residential System.
FEDERAL COMMUNICATIONS COMMISSION
(FCC) Part 1S STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following
statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the
manufacturer's instructions, may cause interference to radio and television reception. It has been t pe tested and found to comply with
& the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC ules, which are desi ned to provide
1?
reasonable protection against s~h interference in a residential installation. However, there is no guarantee that inte erence will not
occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
c If using an indoor antenna, have a quality outdoor antenna installed.
Reorient the receiving antenna until interference is reduced or eliminated.
Move the radio or television receiver away from the receiver/control.
Move the antenna leads away from any wire runs to the receiverkontrol.
9 Plug the receiverkcmtrol into a different outlet so that it and the radio or television receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user or
installer may find the following booklet prepared by the Federal Communications Commission helpful:
"interference Handbook"
This booklet is available from the U.S. Government Printing Office, Washington, DC 20402.
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's
Manual. Unauthorized changes or modifications muld void the user's authority to ooarate the eauiDment.
IN THE EVENT OF TELEPHONE OPERATIONAL PROBLEMS
In the event of telephone ocwrational rxoblems, disconnect the control by removina the DIUUfrom the RJ31 X wall iack. We recommend
that your certified" installer demonstrate disconnecting the phones on installfiion of the system. Do not disconnect the phone
connection inside the control/communicator. Doing so will result in the loss of your phone lines. If the regular phone works correctly
after the control/communicator has been disconnected from the phone lines, the control/communicator has a problem and should be
returned for repair. If upon disconnection of the controlkommunicator, there IS still a problem on the line, notify the telephone company
that they have a problem and request prompt repair service. The user may not under any circumstances (in or out of warranty) attempt
any service or repairs to the system. It must be returned to the factory or an authorized service agency for all repairs.
-40-