Table of Contents
Advertisement
Power Xpress™ Bollard Charge Station
Installation Guide
25. Position the strain relief at the bottom of the
side slot metal mounting bracket in the steel
bollard. Position such that the rubber grommet
(D) seats on the opening of the lower plastic
bollard cover.
D
C
A. Inner strain-relief nut
B. Metal mounting bracket
C. Seal
D. Rubber grommet
Figure 27. Strain Relief Placement
EL-50600-17 Rev. A
A
B
26. Tighten the inner strain-relief nut (A) inside the
bollard hand tight. Using expandable pliers,
tighten the nut an additional 1/4 turn.
Figure 28. Tightening the Strain-Relief Nut
NOTE: Do not overtighten the strain-relief nut. The
grommet may pull through.
19
Advertisement
Table of Contents
