Table of Contents
Advertisement
Power Xpress™ Bollard Charge Station
Installation Guide
STANDARD INSTALLATION
1.
Lay down the bollard box and remove the
banding.
2.
Lift the top off the box and remove the bollard
from the packaging material.
3.
Remove the upper cover from the bollard
assembly by removing the cable-management
retaining screws (E) on the rear of the bollard.
4.
Remove plastic bag containing locating set
screw (not shown) from inside bollard.
E
D
A. Upper plastic cover
B. Metal Bollard
C. Lower plastic cover (Do not remove)
D. Seal
E. Cable-management retaining screws
Figure 9. Bollard Disassembly
EL-50600-17 Rev. A
NOTE: The upper and lower plastic bollard covers
are a matched set and cannot be used inter-
changeably with those from other bollards.
The standard installation design for the Power
Xpress Bollard is a bolt-down external plate.
The standard diameter of the bollard is approxi-
mately 7 in. The bollard height will vary with the
application.
A
Figure 10. Typical Installation
B
C
15/16 in.
Figure 11. Base Plate Dimensions
10 in.
7½ in.
10 in.
7½ in.
13
Advertisement
Table of Contents
