Table of Contents
Advertisement
User- Programmable Fea tures (Con tin ued)
Programs a remote control from any other Clifford system (that uses ACG 2
NOTE 5:
n
technology) to arm or disarm the vehicle. For instance, to set the button
combination of the other car's master remote control to arm/disarm the system, select
column 4, row 1, then transmit the
you are programming. The system will respond with one chirp. Immediately press the
button combination a second time. The system will respond with two chirps. The other
vehicle's remote will now arm/disarm the system by pressing the
simultaneously.
This feature can be controlled by a secondary remote or any remote control
NOTE 6:
n
of any other ACG 2 system, after that remote has been programmed to arm/disarm this
system. Select the row and column number, then transmit the unused button on the
other remote that you want to use to perform that function. The system will respond
with the same number of chirps as the row number. Please note that you must first set a
button on the remote that will arm/disarm the system (column 4, row 1) before these
others will be accepted.
Installer- Programmable Fea tures
To access the installer-programmable features, use the same procedure as on page 15, but
after completing step 4, continue to press and hold the
another 10 seconds. You'll hear 3 chirps to indicate the system is in installer-program mode.
Table of Installer-Programmable Features: 1 chirp = OFF, 2 chirps = ON.
Fea ture
Un marked 1
Se lect
Single/Double Lock
1
Pulse
(1 chirp/2 chirps)
Single/Double
2
Unlock Pulse
(1 chirp/2 chirps)
Lock/Unlock Pulse
3
1 second/3 second
(1 chirp/2 chirps)
4
NOT USED
Program RPM
5
(Requires Optional
IntelliStart 4)
Once this feature is selected, you will hear one chirp to confirm that the
NOTE 1:
timer has started. You can set this anywhere from one to 4.25 minutes (255
seconds). When the desired duration has been reached, press the unmarked side of
the PlainView 2 switch. You will hear two chirps to confirm the new system timer
duration.
NOTE 2: After programming either gas or diesel, you must perform the mandatory RPM
programming.
+
button combination from the remote
side of the PlainView 2 Switch for
Un marked 2
Accessory Output Timer
Duration
(10 Seconds)
NOTE 1
Auxiliary A type
(Pulsed/Timed/Latched)
(1 chirp/2 chirps/3 chirps)
Auxiliary B type
(Pulsed/Timed/Latched)
(1 chirp/2 chirps/3 chirps)
Diesel Engine/Gas Engine
(1 chirp/2 chirps)
(Requires Optional
IntelliStart 4)
NOTE 2
Program Optional
SmartWindows 4 or
Learn PageMate 4 ID
16
+
and
buttons
Un marked 3
Door Ajar
Warning/Delayed
Courtesy Lights
(1 chirp /2 chirps)
Auxiliary A Interlock
(On/ Off)
Auxiliary B Interlock
On/Off
AutoActivate Auxiliary B
(On/Off)
NOT USED
Advertisement
Table of Contents
