Table of Contents
Advertisement
Sys tem Check list & Trou ble shoot ing (Con tin ued)
Step 10.
Test the door trig ger cir cuit.
Rearm the sys tem. Wait at least 10 seconds (if the vehicle has delayed or dimming courtesy
lights, be sure to wait at least 10 seconds after the interior lights have turned off). Use the key
to unlock and open the driver's door.
nSiren sounds, parking lights flash repeatedly. This is the correct response, proceed to
step 11. (You can silence the siren by press ing the
once or disarm by pressing the button twice.)
nSiren does not sound immediately. If the alarm does not sound im me di ate ly when one
of the doors is opened, make sure that that door's pin switch is work ing prop erly and,
when open, is con sis tently show ing less than 1.5 volts if the ve hi cle has
negative- switching door trig gers or more than +11 volts if the ve hi cle has
positive- switching door trig gers, also make sure the pin switch is connected to the
correct wire. If not, then the door pin switch (or pin switches) is ei ther de fec tive or in
need of clean ing.
Step 11.
Test the trunk trig ger cir cuit.
Arm the system, then use the key to unlock the trunk.
nSi ren sounds im me di ate ly, parking lights flash re peat edly. This is the correct
response, proceed to step 12. (You can silence the siren by press ing the button on the
re mote con trol or disarm by pressing the twice.)
nAlarm does not sound immediately. If the alarm does not sound im me di ate ly, make
sure that the trunk pin switch is work ing prop erly and, when open, is con sis tently
show ing less than 1.5 volts. Also make sure the trunk pin switch is connected to the
correct wire. If not, the trunk pin switch must be thor oughly cleaned or re placed, or
polarity may need to be inverted.
Step 12.
Test the AutoArming fea ture.
Turn the ignition "ON" and let the car idle for 10 seconds. Turn the ignition "OFF," then
open and close the door. Wait five seconds.
nParking lights flash twice. 25 seconds later, the vehicle arms passively as indicated by
a rapidly flashing LED. This is the correct response, proceed to step 13.
nSystem does not passively arm.
§ Make sure that AutoArming has been turned on using the programming instructions
on page 15.
§ Verify the door trigger connection (see step 10).
Step 13.
Test the AutoArming By pass fea ture.
Disarm the system. Turn the ignition to the "ON" position, then turn the ignition "OFF."
nOne Chirp. This is the correct response, wait 30 seconds after the interior lights have
turned off to insure the system does not passively arm. Proceed to step 14.
Step 14.
Test remote control range.
Stand approximately 40 feet from the vehicle and use the remote control to arm and disarm
the system.
nThe Cyber 4 will re spond with the pre vi ously noted in di ca tions for arm ing and
dis arm ing. If not:
§ Re po si tion the antenna as high up as possible un der the dash or on the windshield and
as far as pos si ble from heavy wire looms and metal.
§ Make sure that the re mote con trol bat tery meas ures at least 3 volts while trans mit ting.
§ Make sure that the volt age at the con trol unit be tween the 5A fused power line and
each of the two ground lines meas ures at least 12.0 volts (if less, make sure both
chas sis grounds are solid; if the grounds are solid, the ve hi cle battery may need
charg ing, serv ic ing or re place ment).
button on the re mote con trol
20
Advertisement
Table of Contents
