Special Functions - Thermo Scientific DSP2 Installation And Operation Manual

Path: Setup/Special
The menus under special should only be set and adjusted after reading the pertinent section of this manual.
Language
Select from English, French and Spanish. When French or Spanish is selected, only commonly used menus will be displayed in
that language, all others will remain in English.
Input/Outputs
This menu sets and checks the condition of various inputs and outputs of the detector.
Inputs
This allows you to view the state of the following inputs:
Photo eye (infeed P.E.)
Reject confirm 1
Reject confirm 2
Shaft encoder
Infeed Photo eye polarity can be changed in this menu. Reject confirm and shaft encoder are not changeable.
Output
The state of the reject and fault outputs can be monitored. The polarity of the reject output can be inverted from this menu. The
fault output cannot be inverted due to its fail-safe nature.
Function Key
From this menu, the user can select which function will occur when the Function hard key is pressed.
I/O 2
From this menu, the function of I/O 2 in the power supply/terminal box can be chosen. Select from:
Reject sensor 2 (reject confirm 2)
Auxiliary reject (second reject output)
External suppression
Password key lock (external key switch password access)
Unused
Note
: The correct device type must be installed for any of the above functions to work. Contact Goring Kerr for assistance.
Fault Configure
From this menu the following functions can be accessed:
Reboot (will reset the processor)
Frequency (displays the frequency of the control panel)
Configure fault
Fault

Special Functions

36