Table of Contents
Advertisement
P-4
Connection procedure (continued)
Connecting a video device (composite video/S video device)/stereo amplifi er
This monitor can be connected to a composite video or S video device or a stereo amplifi er.
Refer to the user's manual of the composite video or S video device or the stereo amplifi er for details. (Cables shown in the fi gure
below are commercially available.)
•
To connect a video device to the VIDEO IN connector (VIDEO IN or S-VIDEO IN) on the monitor, use a BNC cable or an S video
cable. For connection to the audio input connector on the monitor, use an audio cable (ø3.5-mm stereo mini – RCA). Connect the
connectors of the audio cable (RCA) correctly. For connection to the VIDEO IN connector, select [VIDEO] using the INPUT button
on the monitor or the VIDEO button on the wireless remote control. For connection to the S-VIDEO IN connector, select [S-VIDEO]
using the INPUT button on the monitor or the S-VIDEO button on the wireless remote control.
•
To connect two monitors, connect one end of a BNC cable to the VIDEO OUT connector of the fi rst monitor and the other end to
the VIDEO IN connector of the second monitor.
NOTE:
• In the daisy chain connection, you can connect up to 5 monitors (when using 5-meter cables). However, the maximum number of
connectable monitors may be limited depending on the connected devices to be used. It is recommended to check the number
of connectable monitors in advance in your installation environment.
• When an analog signal is transmitted through the daisy chain, the picture quality such as brightness and sharpness degrades at
the latter devices in the daisy chain connection.
• When different monitors need to be adjusted so that their tint can be identical, such as when using multiple screens, it is
recommended to use a signal distributor (commercially available).
•
When connecting a stereo amplifi er to the monitor, be sure to turn off the power of the stereo amplifi er. For connection to the
AUDIO ANALOG OUT connector on the monitor, use an audio cable (ø3.5-mm stereo mini – RCA). Connect the connectors of
the audio cable (RCA) correctly. Be sure to turn on the monitor fi rst, and then turn on the stereo amplifi er.
•
The selected audio input signal is output from the AUDIO ANALOG OUT connector.
LCD monitor (fi rst monitor)
AUDIO
ANALOG OUT
VIDEO OUT
BNC cable
Audio cable (ø3.5-mm stereo mini – RCA)
Audio cable
(ø3.5-mm stereo mini – RCA)
BNC cable
S video cable
AUDIO
ANALOG IN
VIDEO IN
S-VIDEO IN
To audio input
English-23
(composite video/S video device)
To audio output
To video output
LCD monitor (second monitor)
To S video output
VIDEO IN
Stereo amplifi er
External speakers
Video device
Advertisement
Table of Contents
