Using The Monitor Without The Bezel - Mitsubishi Electric MTD701S User Manual

P-2 Installing the monitor (continued)

Using the monitor without the bezel

CAUTION:
• MDT701S satisfi es the UL requirements as long as it is used
with the bezel attached. When using the monitor without
the bezel, in which case the monitor doesn't satisfy the UL
requirements, cover the UL certifi cation marking on the rear
panel with the supplied label.
• To prevent static damage to circuit boards, attach the
protective cover to the LCD panel.
1. Assemble the supplied protective cover according to the
following procedure.
Peel off the separators.
2. Unscrew the screws (a) that hold the bezel to remove the
bezel from the monitor.
CAUTION:
If you remove other screws than the screws (a), the bezel
falls apart. If you do so, the bezel may fall, causing injury or
damaging the monitor.
(a): Screws for securing the bezel (M3, 18 pcs.)
(a)
(a)
3. Peel off the separators from the protective cover (b)
assembled in step 1 and then attach the protective cover to
the LCD panel.
CAUTION:
Never touch the circuit boards because they may be
damaged.
(b)
4. Cover the UL certifi cation marking on the rear panel with
the supplied label (c).
English-16
Carry out as necessary
Peel off the separators.
(c)