How To Mount And Attach Options To The Lcd Monitor - Mitsubishi Electric MDT321S User Manual

How to Mount and Attach Options to the LCD Monitor

You can attach mounting accessories to the LCD monitor in
one of the following two ways:
1. In the upright position
2. Lay the screen face down
Table
Lay the protective sheet on a table, which was wrapped
around the monitor when it was packaged, beneath the
screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow correct
mounting procedures could result in damage to the
equipment or injury to the user or installer. Product warranty
does not cover damage caused by improper installation.
Failure to follow these recommendations could result in
voiding your warranty.
When using with other mounting accessory, it must be a
VESA-compatible mounting method and the screws must be
M6 of size and 10mm or longer of length under
consideration of the thickness of the mounting method.
(Recommended torque: 470 - 550N•cm). MITSUBISHI
ELECTRIC recommends using mounting interface that
comply with TÜV-GS and/or UL1678 standard in North
America.
Downloaded From TV-Manual.com Manuals
3. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram below.
4. To avoid falling down
Fasten the LCD monitor to wall using a cord or chain,
which is sufficient to support the weight of the LCD monitor
(approx. 16.4kg).
Protective Sheet
Tabletop Stand
Before moving the LCD monitor, the cord or chain should be
removed.
5. To prevent the main power switch from
being changed
To prevent the ability to use the main power switch, please
attach the main switch, which is enclosed as an accessory.
NOTE: With the main power switch cover in place, the main
Screw
English-11
1-13
Get other manuals https://www.bkmanuals.com
358mm
Screw Holes
Cord or Chain
Clamper
Screw
power switch cannot be turned off. Remove main
power switch cover in order to switch off the display.
Main switch cover