Volvo S60 Installation Instructions Manual page 14

Installation instructions, accessories - Body kit Installation instructions, accessories - Body kit
Volvo Car Corporation Göteborg, Sweden Volvo Car Corporation Göteborg, Sweden
32
33
© VolvoCar Corporation, 2004 Printed in Sweden © VolvoCar Corporation, 2004 Printed in Sweden
Drill through the existing holes in the rear edge of the front wheel arch and
through the front end of the panel. Use a 5 mm (3/16") diameter drill bit
Remove any swarf
Secure the panel at the rear edge of the front wheel arch. Use two blind rivets
(from the kit).
M8401049
Drill through the existing holes in the front edge of the rear wheel arch and
through the rear end of the panel. Use a 5 mm (3/16") diameter drill bit
Remove any swarf
Secure the panel at the front edge of the rear wheel arch. Use two blind rivets
(from the kit)
Repeat points 26-36 on the other side of the car
M8401050
Reinstall the rear wheels. Tighten the wheel studs. Tighten to 140 Nm (103 lbf.
ft).
Note!
Leave the car indoors for 2 hours after carrying out the work. Do not wash the
car for 48 hours.
30664734 30664734
Page 14 of 14