Volvo S60 Installation Instructions Manual page 12

Accessories - body kit

Hide thumbs Also See for S60:

Installation instructions, accessories - Body kit

Volvo Car Corporation Göteborg, Sweden

28A

28B

Remove the top edge / rear edge of the panel. Use a plastic weatherstrip tool.

The panel is secured with a clip in the rear wing

Continue forwards. Pry out the panel along the door sills. The panel is secured

with eight clips

Then disconnect the panel from the front wing. The panel is secured with two

clips

Place the panel to one side.

M8401228

Clean the tops of the door sills along the car. Wipe dry

Clean using isopropanol Volvo P/N 1161721. Wipe dry.

M8401229

Illustration A

Take a new panel and rubber strips from the kit. Press two new clips into place

on the panel. The rubber strips for the panels are specific to the left and right-

hand sides, as well as for front and rear. Check the old panels. Check where

each rubber strip is to be located

Press new rubber strips into place on the panel.

Illustration B

M8401039

Note!

The rear clip on the new rear rubber strips must be heated and pressed into

place. Heat using a soldering iron.

R8401109

30664734

Page 12 of 14