Volvo S60 Installation Instructions Manual page 13

Accessories - body kit

Hide thumbs Also See for S60:

Installation instructions, accessories - Body kit

Volvo Car Corporation Göteborg, Sweden

Apply adhesive (Volvo P/N 1161767), at the start of the radius and inwards, to

all projections on the vehicle sill. The bead of adhesive must be approximately

4 mm (5/32") wide.

M8102019

Remove the backing tape from the mounting tape on the panel.

M8401079

Note!

Two people are necessary to carry out installation of the new panel. Ensure that the

panel is lifted to a height in relation to the sill sufficient so that the panel does not smear

the bead of adhesive.

The front and rear edges of the wing liners must cover the ends of the side

panel. Align the panel with the car. Position the locating pin in the centre hole on

the top of the sill

M8401048

Press the front and rear clips for the panel into place in the holes in the sills

Press the panel firmly into place against the sills along the surfaces where the

tape is located

Secure the bottom edge of the panel against the bodywork using eight new clips

from the kit

Remove any adhesive residue that has been pressed out.

30664734

Page 13 of 14