Volvo S60 Installation Instructions Manual page 11

Installation instructions, accessories - Body kit Installation instructions, accessories - Body kit
Volvo Car Corporation Göteborg, Sweden Volvo Car Corporation Göteborg, Sweden
22
23
24
25
© VolvoCar Corporation, 2004 Printed in Sweden © VolvoCar Corporation, 2004 Printed in Sweden
Secure the new strap for the cover in the hole in the car body. Press the cover
into the spoiler.
M8401198
Remove the rear wheels
Drill out the two rivets in the front edge of the rear wheel arch. Use a Ø 6.5 mm
(1/4 ") drill bit
Remove the remains of the rivets.
M8401090
Drill out the two rivets in the rear edge of the rear wheel arch. Use a Ø 6.5 mm
(1/4 ") drill bit
Remove the remains of the rivets.
M8401089
Knock out the centres of the seven clips securing the bottom edge of the door sill
panel. The eighth rear clip must be drilled out. Use a 5 mm (3/16") diameter drill
bit. Drill out the centre pin
Remove the clip
Remove the lower section of the panel together with the clips from the
bodywork.
M8401098
30664734 30664734
Page 11 of 14