Installing A Tape Drive - IBM System x3650 Installation Manual

2.5-inch drives
To install a drive in a hot-swap bay, complete the following steps:
Attention:
than 10 minutes without either a drive or a filler panel installed in each bay.
1. Read the safety information that begins on page v, and "Installation guidelines"
2. Remove the filler panel from one of the empty hot-swap bays.
3. Install the hard disk drive in the hot-swap bay:
If you have other optional devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 32.

Installing a tape drive

For information about installing an optional tape drive, see the User's Guide on the
IBM System x Documentation CD, which comes with the server. See
http://www.ibm.com/servers/eserver/serverproven/compat/us/ for a list of supported
tape drives.
To maintain proper system cooling, do not operate the server for more
on page 9.
a. Make sure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive assembly with the guide rails in the bay.
c. Gently push the drive assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive status LED to verify that the hard disk drive is
operating correctly.
If the amber hard disk drive status LED for a drive is lit continuously, that
drive is faulty and must be replaced. If the green hard disk drive activity LED
is flashing, the drive is being accessed.
Note: You might have to reconfigure the disk arrays after you install hard disk
drives. See the RAID documentation on the IBM ServeRAID Support CD for
information about RAID controllers.
Chapter 2. Installing optional devices
19