Operation - Gardena SR 1600 Operating Instructions Manual

5. Operation

Use as a Pond Silt Remover :
3
4
1
4
A
Operation as Wet Suction Unit :
3
3
B
The higher the filter tray
less the suction power.
1. Pull mains plug of pond silt remover out of electric socket.
2. Position the filter tray
2 pond, max. 0.5 m above the surface of the water and so that
it will not overflow.
3. Insert the round end of the discharge hose
discharge opening of the filter tray
5
The non-return flap
discharge hose
4. Lay the discharge hose
gradient, so that the hose is self-draining.
5. If desired, attach the fine filter bag
discharge hose
0
6. Attach the desired nozzle
2
tube .
7. Insert the Pond Silt Remover mains plug into a power socket.
8. Set the ON switch
When the collecting tank is full, the dirty water is drained via
the discharge hose
pond silt remover switches itself on again automatically.
9. Guide the nozzle on to the bottom of the pond. Then suck up
the dirt with slow and even movements.
10. After use, turn the ON switch
1. Pull mains plug of Wet Suction Unit out of electric socket.
2. Insert stopper plug
filter tray
B
3. Attach the wide nozzle
2
tube .
4. Insert the Wet Suction Unit mains plug into a power socket.
5. Set the ON switch
When the collecting tank is full, the suction unit switches off.
6. When it stops sucking, the filter tray
A
switch
2
7. At the chosen discharge location remove the stopper plug
and empty the filter tray
1
3
above the surface of the water, the
3
at least 2 m from the edge of the
0
is located at the outlet of the
4
.
4
on ground with a falling
4
(see 3. Function).
1
(see 3. Function) to the suction
A
to position (I) ON.
4
over a 25 second period. Then the
A
B
in the lower discharge opening of the
3
.
1
(see 3. Function) to the suction
A
to position (I) ON.
to position (0) OFF.
3
.
4
into the lower
3
.
5
over the end of the
to the (0) OFF position.
3
is full. Then set the
B
13