Troubleshooting; Technical Data - Gardena SR 1600 Operating Instructions Manual

8. Troubleshooting

Problem
The Pond Silt Remover
sucks nothing up
Reduced suction power
The Pond Silt Remover
does not empty
CAUTION !
If other faults occur, please contact GARDENA Service.

9. Technical data

Mains voltage / mains frequency 230 V AC / 50 Hz
Rated power
Connection cable
Max. delivery capacity
Filter tray volume
Suction hose length
Discharge hose length
Max. particle size for suction
Liquid temperature
1)
Noise level
1)
according to 98 / 37/ EC
DANGER ! Electric shock !
V Disconnect the Pond Silt Remover at the mains before
rectifying any faults.
Probable Cause
Discharge hose wrongly fitted.
Pond Silt Remover too high
above the surface of the water.
Foam filter, suction tube, suction
hose or fine filter bag dirty.
The filter bag is full.
Discharge hose kinked or laid
without a falling gradient.
Filter tray and discharge hose
dirty.
Work on the electrical parts must only be carried out by
GARDENA Service.
SR 1600 (Art. 7946)
1400 W
4 m H05-VV
1600 l / h
Approx. 27 l
4 m
2 m
20 mm
4 °C - 35 °C
< 85 dB (A)
Remedy
v The non-return flap in the
discharge hose should not
be plugged into the filter tray
and must be at the outlet
from the discharge hose.
v Position the Pond Silt
Remover max. 0.5 m
above the surface of
the water.
v Clean the Pond Silt Remover
(see 7.Maintenance).
v Replace filter bag.
v Lay the discharge hose so
that it is not kinked and has
a slightly falling gradient.
v Clean filter tray and
discharge hose.
15