Levelling The Machine; Room Ventilation; Washer-Dryer Stack; Before Moving The Tumble Dryer Again (E.g. When Moving Houses) - Miele T 8823 C Operating Instructions Manual

Levelling the machine

The machine must be perfectly level to
ensure safe and proper operation.
^ The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
The air inlet and outlet vents on
the front of the machine must not be
covered as this would prevent
sufficient ventilation for cooling the
condenser unit.
,
The gap between the base of the
dryer and the floor must not be
minimised by a plinth or thick-piled
carpet as this will prevent a
sufficient intake of cold air.

Room ventilation

The air which is taken in when the dryer is
in operation is blown out of the vents on
the front of the machine and warms up
the air in the room. It is very important,
particulary if the room is small, to ensure
adequate ventilation. Opening a window,
for example, will allow more air to enter
the room. Otherwise running times and
energy consumption could be increased.

Washer-dryer stack

The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. The
appropriate "WTV" stacking kit* to
match your dryer is required.
* accessory available to order
,
Stacking kits must only be
installed by a suitable qualified fitter.
Before moving the tumble dryer
again (e.g. when moving houses)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the tumble dryer is tipped up
when it is being moved. It is a good
idea to run the Warm air programme for
approximately 1 minute before moving
it. Any remaining condensed water will
then be fed into the condensed water
container or out through the drain hose.
Installation
43