Miele T 8823 C Operating Instructions Manual page 34

Condenser tumble dryer
Hide thumbs Also See for T 8823 C:
Table of Contents

Advertisement

Problem solving guide
Problem
The following
flashes at the
end of a
programme:
—œ–...C~–...Cœ˜...
The Clean out
airways
indicator light
comes on.
The programme
is cancelled.
The Clean out
airways
indicator light
comes on.
The buzzer
sounds.
The Empty out
container
indicator light
comes on.
The buzzer
sounds.
34
Possible cause
The programme has finished
but the laundry is still cooling
down.
The dryer is not working
efficiently or economically.
Possible cause: Blockages
due to fluff or detergent
residues.
See above for possible
causes and their remedies.
The condensed water
container is full or there is a
kink in the drain hose.
Remedy
You can remove the laundry
and spread it out to allow the
heat to dissipate, or leave it in
the dryer to cool down more.
– Cleaning the filters is
usually all that is required.
However, if the message
does not go out after you
have cleaned the filters,
then also check all the
possible causes described
under "The drying process
goes on too long or even
switches off".
To delete the message:
– Open and close the door
while the dryer is switched
on.
The Clean out airways
indicator light can be
deactivated (see
"Programmable functions").
To delete the fault message:
– Open and close the door
while the dryer is switched
on.
– Start a programme.
– If this warning appears
again, contact Miele.
– Empty out the condensed
water container.
– Check the drain hose.
To delete the message:
– Open and close the door
while the dryer is switched
on.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T 8843 c

Table of Contents