Table of Contents
Advertisement
Installation
Rear view
a Protruding lid for holding when
moving the machine (see arrows)
b Air inlet vent for cooling the
condenser unit
c Mains connection cable
d Hose for external drainage of
condensed water
e Accessories for connection to a sink
drain outlet
Installation site
,
Make sure the dryer door can be
opened without hindrance after
installation.
Transporting the machine to its
installation site
When moving the dryer, hold it by the
lid where it protrudes to the rear. To
manoeuvre the machine out of its
packing case to its installation site,
hold it by the front feet as well as by
the edge of the lid where it protrudes
to the rear of the washing machine.
42
Building under a continuous worktop
/ in a kitchen run
,
A building-under kit* (Miele
accessory, available to order) with a
coverplate to replace the
appliance's lid is required. It must
be fitted by a suitable qualified
person to ensure electrical safety.
The coverplate included in the
building-under kit replaces the
appliance's lid. It is necessary to fit
the coverplate for electrical safety
reasons.
– Fitting instructions are supplied with
the conversion kit.
– N.B. When built-under, drying times
may be longer.
– The electrical socket must be
located in an accessible position
near the machine.
With niche heights of:
– 830-840 mm, longer screw feet* are
required.
– 870-885 / 915-930 mm, one or two
raising kits* are required.
* accessory available to order
Replacing the lid
If the lid has been removed in order to
fit a coverplate, ensure that, if the lid is
ever replaced, it fits securely into the
rear holders. Otherwise, it is not
properly secured for transport.
Hide quick links:
Advertisement
Table of Contents
