Table of Contents
Advertisement
6. In the Found New Hardware Wizard prompt, choose to display a list
7. Click on Next.
8. Select the driver that you want to install for the device. If you have a
9. Select Other devices from the list of hardware types, then click on
10. Insert the disk containing the driver into the selected drive and click
11. Select the processor device and click on Next.
12. On the final screen, click on Finish to complete the installation.
13. Repeat the process on the peer system.
4.3.2
Network Requirements
The network requirements for clustering are:
•
•
•
•
4-4
Installing and Configuring Clusters
Copyright © 2003 by LSI Logic Corporation. All rights reserved.
of the known drivers to select a specific one.
disk with the driver you want to install, click on Have Disk.
Next.
on OK.
A unique NetBIOS cluster name
Five unique, static IP addresses:
–
Two addresses are for the network adapters on the internal
network.
–
Two addresses are for the network adapters on the external
network.
–
One address is for the cluster itself.
A domain user account for Cluster Service (all nodes must be part
of the same domain)
Two network adapters for each node: one for connection to the
external network, the other for the node-to-node internal cluster
network. If you do not use two network adapters for each node, your
configuration is unsupported. HCL certification requires a separate
private network adapter.
Advertisement
Table of Contents
