Table of Contents
Advertisement
12. Repeat steps 4 through 7 for the second storage adapter.
13. Power down the second server.
14. Attach the cables for the second storage adapter to the shared
15. If a configuration mismatch occurs, enter the <Ctrl> <M> utility, then
16. Save the configuration.
17. Proceed to the driver installation for a Microsoft cluster environment.
4.3.1
Driver Installation Instructions under Microsoft Windows 2000
Advanced Server
After the hardware is set up for the MS cluster configuration, perform the
following procedure to configure the driver under Microsoft Windows
2000 Advanced Server. Note that when the storage adapter is added
after a Windows 2000 Advanced Server installation, the operating
system detects it.
1. When the Found New Hardware Wizard screen displays the detected
2. When the next screen appears, select Search for a suitable driver,
3. Insert the floppy diskette with the appropriate driver disk for Windows
4. Click on Finish to complete the installation.
5. Repeat steps 1 through 4 to install the device driver on the second
Installation and Configuration
Copyright © 2003 by LSI Logic Corporation. All rights reserved.
enclosure, and power up the second server.
go to the Configure-> View/Add Configuration > View Disk menu to
view the disk configuration.
hardware device, click on Next.
and click on Next.
The Locate Driver Files screen appears.
2000, then select Floppy disk drives on the screen and click on
Next.
The Wizard detects the device driver on the diskette; the "Completing
the upgrade device driver" wizard displays the name of the device.
system.
After the cluster is installed and both nodes are in the Microsoft
Windows 2000 Advanced Server, the system detects a SCSI
processor device.
4-3
Advertisement
Table of Contents
