Table of Contents
Advertisement
Figure 2.2
Terminating an Internal SCSI Disk Array
Host Computer
Step 8. Power On Host System
Replace the computer cover, and reconnect the AC power
cords. Turn power on to the host computer. Ensure that the
SCSI devices are powered up at the same time as, or before,
the host computer. If the computer is powered up before a SCSI
device, the device might not be recognized.
During boot, a BIOS message appears.
Detailed Installation
Copyright © 2003 by LSI Logic Corporation. All rights reserved.
Terminator
ID2 – No Termination
ID1 – No Termination
ID0 – Boot Drive
No Termination
MegaRAID 320
SCSI ID 7
2-7
Advertisement
Table of Contents
