Table of Contents
Advertisement
Table 4.1
during each step.
Table 4.1
Nodes and Storage Devices
Step
Set Up Networks
Set up Shared Disks
Verify Disk Configuration
Configure the First Node
Configure the Second
Node
Post-installation
Before installing the Cluster Service software follow these steps:
1. Install Windows 2000 Advanced Server or Windows 2000 Datacenter
2. Set up networks.
3. Set up disks.
To configure the Cluster Service on a Windows 2000-based server, you
must be able to log on as administrator or have administrative
permissions on each node. Each node must be a member server, or
must be a domain controller inside the same domain. A mix of domain
controllers and member servers in a cluster is not acceptable.
4-6
Installing and Configuring Clusters
Copyright © 2003 by LSI Logic Corporation. All rights reserved.
shows which nodes and storage devices must be powered on
Node 1 Node 2 Storage
On
On
Off
On
Off
On
Off
On
On
On
Off
On
On
On
On
On
On
On
Server on each node.
Note:
These steps must be completed on every cluster node
before proceeding with the installation of Cluster Service on
the first node.
Comments
Ensure that power to all storage devices on
the shared bus is turned off. Power on all
nodes.
Power down all nodes. Next, power on the
shared storage, then power on the first
node.
Shut down the first node. Power on the
second node.
Shut down all nodes. Power on the first
node.
Power on the second node after the first
node was successfully configured.
All nodes must be active.
Advertisement
Table of Contents
