After You Have Installed The Storage Adapter; Section 2.4, "After You Have Installed The Storage Adapter - Fujitsu Siemens Computers MegaRAID 320 User Manual

The MegaRAID 320 BIOS Configuration utility prompt times out after
several seconds. The second portion of the BIOS message displays the
MegaRAID 320 storage adapter number, firmware version, and cache
SDRAM size. The numbering of the controllers follows the PCI slot
scanning order used by the host motherboard.
If you want to run the MegaRAID Configuration utility or the WebBIOS
utility at this point, press the appropriate keys when this message
appears:
Press <CTRL><M> to run MegaRAID Configuration Utility, or
Press <CTRL><H> for WebBIOS
2.4

After You Have Installed the Storage Adapter

After storage adapter installation, you must configure the storage adapter
and install the operating system driver. The MegaRAID Software User's
Guide instructs you about the configuration options and how to set them
on your storage adapter.
2-8 MegaRAID 320-1, -2, -2X, -4X Hardware Installation
Copyright © 2003 by LSI Logic Corporation. All rights reserved.
The firmware takes several seconds to initialize. During this
time, the storage adapter scans the SCSI channel(s).