Table of Contents
Advertisement
Chapter 2: Installation Instructions
Audio Connector: F_AUDIO
The audio connector supports HD audio standard. The
front audio connector allows the user to have access to
audio jacks from the back or from the front.
Serial ATA II Connectors: SATA_1, SATA_2, SATA_3, SATA_4, SATA_5, SATA_6
The Serial ATA II connector is used to connect the Serial ATA II device
to the motherboard. These connectors support the thin Serial ATA II ca-
bles for primary storage devices. The current Serial ATA II interface allows
up to 300MB/s data transfer rate. These six serial ATA are capable for the
following configurations: RAID 0, RAID 1, RAID 5, RAID 0+1 and JBOD.
Fan Connectors: CPU_FAN, SYS_FAN, FAN
The fan speed can be detected and viewed in "PC Health Status"
section of the CMOS setup. These fans will automatically turn off
after the system enters S3, S4, and S5 modes.
USB Headers: F_USB1, F_USB2
Besides six USB ports on the rear panel, there are also two 10-pin
hearders on the board with may connect to either the front (provided
that the front panel of your chassis is equipped with the appropriate
interface) or connect to a rear panel USB cable (optional) to provide
additional four USB ports.
IEEE 1394a Connector: F_1394_1
The 1394 expansion can be connected to either the front (provided that the
front panel of your chassis is equipped with the appropriate interface) or
connected to a rear panel 1394 cable (optional).
Port1_L
Port1_R
Port2_R
Sence_send
Port2_L
GND +12V SENSE
1
GND SENSE
1
POWER CONTROL
5V_DUAL
17
Aud_Gnd
Presence_J
Sense1_Return
Empty
Sense2_Return
F_AUDIO
1
SATA II Connector
SYS-FAN
FAN
CPU_FAN
Empty
NC
GND
GND
D+
D+
D-
D-
5V_DUAL
1
F_USB 1/2
10
9
GND
Empty
+12V
+12V
TPB-
TPB+
GND
GND
TPA-
TPA+
1
2
F_1394_1
Advertisement
Table of Contents
