Green Tube Connection; Blue Tube Connection - Watts Premier 5 SV DELUXE Installation, Operation And Maintenance Manual

Green Tube Connection

Drape the green tube connected to the 90° Inlet white plastic elbow on the left side of the
Step 19
Reverse Osmosis Module over to the adapta valve attached to the cold water sink faucet or
attached to the Angle Stop Valve, leaving a gentle curve in the tubing. Cut to desired
length using a sharp knife.
Step 20 Remove a brass nut, plastic delrin sleeve and brass insert from
the parts bag. Place nut on the tube first, then the Delrin sleeve
and then insert the brass Insert into the end of the tube. (Small
taper end of Delrin sleeve must point to the end of tube).
Step 21 Insert the green tube into the ¼" opening until it stops. Slide nut
and sleeve down and thread onto the male pipe threads. Use a
½" wrench to securely tighten.

Blue Tube Connection

Step 22 Position tank in desired location. Stand it upright or lay it on its
side (using the black plastic stand). Measure the blue tube from
the RO module over to the tank and cut it to length.
Step 23 Push blue tube into the brass tee until it stops. Slide brass nut and
plastic Delrin sleeve down until you can thread nut onto the tee.
Use wrench to securely tighten the nut.
Page 9