Table of Contents
Advertisement
Drain Saddle Installation
Step 14
Gather the pieces of the drain saddle
Step 15
The small square black foam gasket with a circle cut out of the middle
must be applied to the inside of the drain saddle. Remove sticky tape
backing and stick to the drain saddle as shown.
Step 16
Drill a ¼" hole through the drain pipe at least 1 ½" above the nut of
the P-trap to allow for the removal of the P-trap if necessary.
Assemble the drain saddle around the drain pipe. Position the
drain saddle over the drilled hole in pipe. Insert screw driver into
the opening of the drain saddle and align with drilled hole in drain
pipe. Using Philips screw driver tighten screws evenly and
securely on both sides of the drain saddle. Attach black
compression nut, but do not tighten at this time. The black tubing
will be installed later.
Caution:
Do not over tighten the screws. It may crack the drain saddle.
Tank Tee Installation
Step 17
Teflon tape must be applied in a clockwise direction. Wrap (7 to 12
turns) around the male pipe threads (MPT) on the Stainless Steel
fitting on top of the tank.
Step 18
Thread the brass tee (supplied in the parts bag) onto the brass
connection on the top of tank. Tighten using an adjustable wrench.
Caution:
Do not teflon tape the compression fitting threads. If taped it will leak.
Drain Saddle fits standard 1 ¼" – 1 ½" drain pipes
1 Black compression nut
1 Semi-circle bracket with opening
2 Screws
1 Foam washer
2 Nuts for screws
1 Semi-circle bracket
Page 8
Hide quick links:
Advertisement
Table of Contents
