Table of Contents
Advertisement
Wave Faucet Installation
Note:
If using the Wave Air Gap Faucet (included), a 1 1/4" hole will be required.
If using a Wave non air gap faucet, a 3/4" hole will be required.
Step 6
Gather and identify the Wave faucet pieces.
Step 7
Remove black stem nut and insert the three tubes (air gap faucet)
through the white gasket with the groove on the gasket toward the
faucet base.
Step 8
Insert the three tubes through the 1 1/4" hole in the sink. The white gasket
must be on top side of the sink.
Step 9
View from under the sink and insert the white plastic spacer as shown. (A
slotted washer is used if it is a non air gap faucet.)
Step 10
Thread the black stem nut back onto the white threaded stem and thighten
within ¼" of plastic spacer. Check the orientation of the faucet above the
sink and tighten the black plastic washer until white plastic spacer is snug
and faucet stands securely on top of the sink. (For a non air gap faucet,
the blue tube will have to be pushed into the faucet fitting at the bottom of
the faucet. Push the tube all the way to the "tube stop" inside the fitting.)
Note:
A dripping or gurgling sound may be heard coming from the air gap hole
on the faucet or the drain when the system is running. This is normal and
in compliance with UPC (Universal Plumbing Code).
Air Gap Faucet
Non Air Gap Faucet
Page 5
• Faucet assembly
• Black Shank Nut
• Spacer
• Gasket
• Faucet assembly
• Black Shank Nut
• Slotted washer
• Gasket
• 3' Blue Tube
Hide quick links:
Advertisement
Table of Contents
