Lubrication - Mercury 496 MAG Bravo Owner's Manual

CA922
71903
1
CA524
Steering System
1
If Steering Cable Has Grease Fittings: Turn steering until steering cable is fully retracted into cable housing.
Apply approximately 3 pumps of grease from a typical hand-operated grease gun. Lubricate at fitting with 2-4-C
Marine Lubricant with Teflon.
Do not grease steering cable while extended. Hydraulic lock could occur and cause loss of steering
control.
NOTE: If steering cable does not have grease fitting, inner wire of cable cannot be greased.
2
Turn steering until steering cable fully extended. Lubricate by applying a thin coat of Special Lubricant 101
on exposed part of cable.
3
Lubricate steering system pivot points with SAE 30W motor oil.
4
On dual engine boats: Lubricate all pivot points, including tie bar pivot points, with SAE 30W motor oil.
5
Upon first starting engine, turn steering wheel several times to starboard, and then port, to ensure that the
steering system operates properly, before getting underway.
CA923
Shift Cable - Typical
6
Lubricate pivot points with SAE 30W motor oil.
CB613
Throttle Cable
7
Lubricate pivot points with SAE 30W motor oil.
52
2
6
71357

Lubrication

WARNING
3
71901
7
INDEX
71904
71359