TANDBERG Codec C90 Administrator's Manual page 36

TANDBERG Codec C90 and Profiles using C90
Contents Contents Introduction Introduction
The Video settings,
cont...
Video Output Composite [5] MonitorRole
The Composite monitor role describes what video stream will be shown on the monitor connected to the
video output Composite connector. Applicable only if the monitor configuration is set to dual or quadruple.
Value space: <First/Second/PresentationOnly/Third/Fourth>
First: Show main video stream.
Second: Show presentation video stream if active, or other participants.
PresentationOnly: Show presentation video stream if active, and nothing else.
Third: Use for remote participants (only for quadruple monitor setup).
Fourth: Use for remote participants (only for quadruple monitor setup).
Example: Video Output Composite 5 MonitorRole: First
Video Output Composite [5] OverscanLevel
Some TV's or other monitors may not display the whole image sent out on the systems video output, but
cuts the outer parts of the image. In this case this setting can be used to let the system not use the outer
parts of video resolution. Both the video and the OSD menu will be scaled in this case.
Value space: <Medium/High/None>
Medium: The system will not use the outer 3% of the output resolution.
High: The system will not use the outer 6% of the output resolution
None: The system will use all of the output resolution.
Example: Video Output Composite 5 OverscanLevel: None
Video Output Composite [5] Resolution
Select the preferred resolution for the monitor connected to the video output Composite connector. This
will force the resolution on the monitor.
Value space: <PAL/NTSC>
Range: Select PAL or NTSC resolution.
Example: Video Output Composite 5 Resolution: NTSC
D14635.03—MAY 2010
Advanced config.
Advanced configuration Advanced configuration Password protection Password protection About monitors About monitors Audio matters Audio matters
Video Selfview
The Video Selfview setting determines whether or not the main video source (self view) should be
displayed on screen.
Value space: <On/Off>
On: Show self view on screen.
Off: Hide self view on screen.
Example: Video Selfview: On
Video WallPaper
Select a background picture for the screen.
Value space: <None/Growing/Summersky/Custom>
None: No wallpaper will be displayed on screen.
Summersky, Growing: Select one of the predefined wallpapers to be displayed on screen.
Custom: The custom wallpaper must be uploaded to the codec from the web interface.
1) On the video system: Find the IP address of the codec. Open the menu on screen and go to Home
> Settings > System information to find the IP Address.
2) On your computer: Open a web browser and enter the IP address of the codec. Select
"Wallpaper" from the menu, browse for the file, and press the "Upload" button.
3) On the video system: Open the menu on screen and go to Home > Settings > Wallpaper >
Custom. Give it a few seconds to display the new picture. If the picture does not show, toggle once
between "None" and "Custom" wallpaper to make the change take effect.
Example: Video Wallpaper: Summersky
36
Administrator guide
Appendices Appendices Contact us Contact us
www.tandberg.com