TANDBERG Codec C90 Administrator's Manual page 13

TANDBERG Codec C90 and Profiles using C90
Contents Contents Introduction Introduction
The Audio settings,
cont...
Audio Output Line [1..6] Mode
Set the audio output line mode.
Value space: <On/Off>
On: Enable the Audio Line output.
Off: Disable the Audio Line output.
Example: Audio Output Line 1 Mode: On
Audio Output Line [1, 3] Type
Determines if the Audio Line output connector is an analog or digital type output.
Value space: <Auto/SPDIF>
Auto: If a TANDBERG Digital NAM is detected then SPDIF mode will be selected, otherwise analog
mode will be selected.
SPDIF: Set to SPDIF when you want the line output to be in digital mode.
Example: Audio Output Line 1 Type: Auto
Audio Output Line [2, 4, 5, 6] Type
Line output 2, 4, 5, 6 are dedicated analog outputs, hence type can be set to analog only.
Value space: <Analog>
Analog: Can be set to analog only.
Example: Audio Output Line 2 Type: Analog
Audio SoundsAndAlerts KeyTones Mode
The system can produce a sound every time a key on the remote control is pressed.
Value space: <On/Off>
On: There will be a sound indicator when pressing keys on the remote control.
Off: The remote control Key Tones is switched off.
Example: Audio SoundsAndAlerts KeyTones Mode: Off
Audio SoundsAndAlerts RingTone
Select the ring tone for incoming calls.
Value space: <Marbles/IceCrystals/Polaris/Alert/Discrete/Fantasy/Jazz/Nordic/Echo/Rhythmic>
Select a tone from the list of ring tones.
Example: Audio SoundsAndAlerts RingTone: Jazz
D14635.03—MAY 2010
Advanced config.
Advanced configuration Advanced configuration Password protection Password protection About monitors About monitors Audio matters Audio matters
The Audio settings,
cont...
Audio SoundsAndAlerts RingVolume
Set the ring tone volume for an incoming call. The value goes in steps of 5 from 0 to 100 (from -34.5dB to
15dB). Volume 0 = Off.
Value space: <0..100>
Range: Select a value from 0 to 100.
Example: Audio SoundsAndAlerts RingVolume: 50
Audio Volume
Set the volume on the loudspeaker. The value goes in steps of 5 from 0 to 100 (from -34.5dB to 15dB).
Volume 0 = Off.
Value space: <0..100>
Range: Select a value from 0 to 100.
Example: Audio Volume: 70
13
Administrator guide
Appendices Appendices Contact us Contact us
www.tandberg.com