TANDBERG Codec C90 Administrator's Manual page 15

TANDBERG Codec C90 and Profiles using C90
Contents Contents Introduction Introduction
The Camera settings,
cont...
Cameras Camera [1..7] Flip
With Flip mode (vertical flip) you can flip the image upside down.
Value space: <Auto/On/Off>
Auto: When the camera is placed upside down the image is automatically flipped upside down. Use
this setting with cameras that can be mounted upside down, and that can auto detect that the camera
is mounted upside down.
On: When enabled the video on screen is flipped. This setting is used with cameras that can be
mounted upside down, but cannot auto detect that the camera is mounted upside down.
Off: Display the video on screen the normal way.
Example: Cameras Camera 1 Flip: Off
Cameras Camera [1..7] DHCP
Applies to cameras which supports DHCP. The TANDBERG PrecsisionHD 1080p camera supports DHCP.
The camera must be connected to a LAN. When set, the command enables support for SW upgrade of
daisy chained cameras. It will enable the camera's DHCP function and force start of MAC and IP address
retrieval. Remember to reset the DHCP when the camera is no longer connected to a LAN.
Value space: <On/Off>
On: Enable DHCP in the camera. The camera is automatically re-booted. After re-boot the DHCP is
started and the IP address will be retrieved. Run the commnand "xStatus Camera" for result.
Off: Disable DHCP in the camera. NOTE! Set to Off when the camera is not connected to a LAN.
Example: Cameras Camera 1 DHCP: Off
Cameras Camera [1..7] Gamma Mode
Applies to cameras which supports Gamma mode. The Gamma Mode setting enables for gamma
corrections. Gamma describes the nonlinear relationship between image pixels and monitor brightness.
The TANDBERG PrecisionHD 720p camera supports Gamma Mode. Not supported on The TANDBERG
PrecisionHD 1080p camera.
Value space: <Auto/Manual>
Auto: Auto is the default and the recommended setting.
Manual: In severe light conditions, you may switch mode to manual and specify explicitly which gamma
table to use by setting the Gamma Level.
Example: Cameras Camera 1 Gamma Mode: Auto
D14635.03—MAY 2010
Advanced config.
Advanced configuration Advanced configuration Password protection Password protection About monitors About monitors Audio matters Audio matters
The Camera settings,
cont...
Cameras Camera [1..7] Gamma Level
By setting the Gamma Level you can select which gamma correction table to use. This setting may be
useful in difficult lighting conditions, where changes to the brightness setting does not provide satisfactory
results. NOTE! Requires the Camera Gamma Mode to be set to Manual.
Value space: <0..7>
Range: Select a value from 0 to 7.
Example: Cameras Camera 1 Gamma Level: 0
Cameras Camera [1..7] IrSensor
The IR sensor LED is located in the front of the camera and flickers when the IR sensor is activated from
the remote control. Both the TANDBERG camera and codec has an IR sensor. You would normally choose
just one of them to be active at a time.
Value space: <On/Off>
On: Enable the IR sensor on the camera.
Off: Disable the IR sensor on the camera.
Example: Cameras Camera 1 IrSensor: On
15
Administrator guide
Appendices Appendices Contact us Contact us
www.tandberg.com