Cleaning Your Baumatic Cooker Hood - Baumatic BTC6720BL User Manual

o Before operating the hood, make sure that it has been installed
by a suitably qualified person, as per the information contained
in Baumatic's installation instructions.
o Find the control panel, which is located at the front right of the
canopy.
o There are several buttons on the control panel, which perform
separate functions.
IMPORTANT: IDEALLY YOU SHOULD SWITCH ON
YOUR HOOD TEN MINUTES BEFORE YOU START TO
COOK, OR AT THE VERY LEAST WHEN YOU BEGIN
COOKING. YOU SHOULD ALSO RUN YOUR HOOD FOR
TEN MINUTES AFTER YOU HAVE FINISHED COOKING.

Cleaning your Baumatic cooker hood

IMPORTANT:
ENSURE
COOKER
SWITCH, SET AT THE WALL FROM THE CABLE.
Cleaning
o Clean the external parts of your cooker hood with mild liquid
detergent and a new damp cloth.
o Never use abrasive powder, corrosive solvents or brushes.
o Never insert pointed objects into the motor's protective grid.
o Only clean the control panel and grease filter grill with mild liquid
detergents and a new damp cloth.
o If you are using the appliance in recirculation mode, then be
sure to replace the carbon filters at the recommended intervals
(see section on "Fitting the carbon filter"). A build up of grease
could cause a fire hazard.
o Never attempt to clean the area above the grease filters.
BEFORE
THAT YOU HAVE
HOOD OFF AT
CLEANING, ALWAYS
SWITCHED
THE OMNI-POLAR
YOUR
15