Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Baumatic BTC6750GL
Summary of Contents for Baumatic BTC6750GL
- Page 1 BTC6750GL/ BTC9750GL Cooker Hood...
- Page 2 User Manual for your Baumatic BTC6750GL/BTC9750GL Cooker Hood 60 cm Cooker hood with LCD display 90 cm Cooker hood with LCD display NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
-
Page 3: Table Of Contents
Contents Page Environmental note IMPORTANT SAFETY INFORMATION Specifications of your BTC6750GL cooker hood Specifications of your BTC9750GL cooker hood Using your Baumatic cooker hood Before first use To use your cooker hood Setting the time of day The timer Cleaning your Baumatic cooker hood... -
Page 4: Environmental Note
ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person. -
Page 5: Important Safety Information
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Technical Department. - Page 6 you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
- Page 7 removing air from your room. Ensure that proper ventilation measures are being observed. o Note that it removes odours from your room, not steam. o Warning - Always ensure that the cooker hood has been disconnected from the power supply before carrying out any work on the hood, including replacing light bulbs.
-
Page 8: Specifications Of Your Btc6750Gl Cooker Hood
Specifications of your BTC6750GL cooker hood PRODUCT DIMENSIONS Height: 565 mm – 1045 mm Width: 600 mm Depth: 500 mm DIMENSIONS OF CHIMNEY SECTION: 276 mm x 303 mm Your stainless steel cooker hood is fitted with: o High extraction tangential motor... -
Page 9: Specifications Of Your Btc9750Gl Cooker Hood
Specifications of your BTC9750GL cooker hood PRODUCT DIMENSIONS Height: 565 mm – 1045 mm Width: 900 mm Depth: 500 mm DIMENSIONS OF CHIMNEY SECTION: 276 mm x 303 mm Your stainless steel cooker hood is fitted with: o High extraction tangential motor o Touch control operation o LCD display o 3 speeds... -
Page 10: Using Your Baumatic Cooker Hood
To use your cooker hood o Make sure that it has been installed by a suitably qualified person, as per the information contained in Baumatic’s installation instructions. o Find the control panel, which is located in the middle of the canopy. -
Page 11: Setting The Time Of Day
switch the lights on, even if the hood is not operating. IMPORTANT: IDEALLY YOU SHOULD TURN ON YOUR HOOD TEN MINUTES BEFORE YOU START TO COOK, OR AT THE VERY LEAST WHEN YOU BEGIN COOKING YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING etting the time of day o Press and hold the timer button, until the first two digits of the... -
Page 12: Cleaning Your Baumatic Cooker Hood
Cleaning your Baumatic cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT YOU HAVE SWITCHED YOUR COOKER HOOD OFF AT THE OMNI-POLAR SWITCH, SET AT THE WALL FROM THE CABL E. Cleaning o Clean the external parts of your cooker hood with mild liquid deter gent and a new damp cloth. -
Page 13: Maintenance
intenance Removing and cleaning the grease filter o Soak the grease filter in hot water and washing up liquid for about an hour. o Rinse it off thoroughly with hot water. o Repeat the process if required. o IMPORTANT: Let the grease filter dry thoroughly before refitting it in the cooker hood. -
Page 14: Changing A Light Bulb
IMPORTANT: BE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FRO YOUR MAINS SUPPLY. o Prior to touching the light bulbs ensure that they have cooled down. o Find the bulb that requires replacement, you will find it located in the light fixture which is inside the exposed section of the canopy. -
Page 15: Fitting The Carbon Filters
the appliance is being used to be used in recirculation mode then it is necessary to fit carbon filters. This will help to absorb unpleasant odours caused by cooking. IMPORTANT: BE REMOVE THE CARBON FILTERS, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED T COOKER HOOD FROM YOUR MAINS SUPPLY. -
Page 16: Installation
Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicate the rating plate are exactly the same as the voltage and frequency in your home. The rat plate can be found behind the grease filter. he manufacturer declines all responsibility in the event of the installer failing to observe all the accident prevention regulations in force, which are necessary for normal use and the regular operation of th... -
Page 17: Before Beginning Installation
correspond with the coloured markings identifying the t in your spur box, please proceed as follows: o The blue wire must be Before beginning i nsta la o Check that the product purc chosen installation area. In addition check whether there is an electrical socket available that will be accessible once the hood mounted. -
Page 18: Installing Your Cooker Hood
appliance is designed to b Ins a t lling your cooker hood IMPORTANT: YOU INSTALLING YOUR COOKER HOOD WHETHER TO USE IT IN EXTRACTION MODE OR RECIRCULATION MODE. PLEASE TURN TO PAGE 24 NOW TO UNDERSTAND THE DIFFERENCES BETWEEN THE TWO MODES. - Page 19 a) The support screw holes are indicated by figure A in this drawing nd the anchoring screw holes are indicated by figure B. 4) Insert raw plugs into all of the holes that you have drilled. 5) Fasten the support screws halfw y in, leaving them 10 mm out of the wall.
- Page 20 Fully tighten the support screws (A) and then screw the anchoring crews (B) through the relevant holes in the cooker hood. Tighten the anchoring screws fully into the wall ) Hang the hood onto the support crews.
-
Page 21: Connecting To External Ducting
8) Connect the coupling to the top of the cooker hood, and then connect a 125 mm ducting hose to the coupling (please note that the ducting hose is not supplied with the appliance). o The other end of the ducting hose should be connec discharge outlet that is suitable for cooking vapours. - Page 22 Lift chimney section D upwards until it reaches the ceiling. You ust ensure that it is perpendicular to the hood. o Mark the side measurement of both sides of chimney section D on the wall with a pencil and then remove c 1) Take the fixing bracket (E) and place it between the two pencil arks that you made in step 9...
- Page 23 Using a 8 mm drill bit, drill out two holes on the pencil markings at you made in step 11. Insert raw plugs into the holes and then use screwdriver to secure the fixing bracket to the wall. o Refit chimney section C to the hood and fix it onto the hood using the two screws that are supplied.
-
Page 24: Attaching The Glass Canopy (Btc9750Gl Only)
o The anchoring bolts (F) should and screws provided with the cooker hood. If you find them already attached to the cooker hood, then you them. Carefully place the glass section (Q) on the upper surfa cooker hood and then slide it back towards the wall. Screw the anchoring bolts (F) through the relevant holes in the glass sect ion (Q). -
Page 25: Completing The Installation
What is a charcoal filter and do I need one? All cooker hoods have a grease filter b ood in recirculation mode, then a charcoal filter must be fitted in addition to the grease filter. -
Page 26: Troubleshooting
MPORTANT: If your cooker hood appears not to be operating roperly, before contacting the Baumatic Service Department, please refer to the c hecklist below. My cooker hood will not start. Check that the hood is connected to the electricity supply Check that the fan speed control is set correctly. - Page 27 Or any installation other han the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
-
Page 28: Contact Details
Technical Advice Telephone (0118) 933 6933 E-mail: sales@baumatic.co.uk technical@baumatic.co.uk Website www.baumatic.co.uk epublic of Ireland 01- 6266 7 Czech Republic Baumatic CR spol s.r.o. mperova 495 6215, Librec zech Republic 420 800 185 263 www.baumatic.cz Slovak Republ Baumatic Slova kia, s.r.o. Skultetyho 1... - Page 32 32 32...
Need help?
Do you have a question about the BTC6750GL and is the answer not in the manual?
Questions and answers