Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Baumatic BTC6740SS
Summary of Contents for Baumatic BTC6740SS
- Page 1 BTC6740SS/ BT9740SS Cooker Hood...
- Page 2 User Manual for your Baumatic BTC6740SS/BTC9740SS Cooker Hood 60 cm Cooker hood with LCD display 90 cm Cooker hood with LCD display NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
-
Page 3: Table Of Contents
Contents Page Environmental note IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your BTC6740SS cooker hood Specifications of your BTC9740SS cooker hood Using your Baumatic cooker hood 10 - 11 Before first use To use your cooker hood 10 – 11... -
Page 4: Environmental Note
ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person. -
Page 5: Important Safety Information
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Technical Department. - Page 6 o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
- Page 7 o Remember that when in extraction mode, your cooker hood is removing air from your room. Ensure that proper ventilation measures are being observed. o Note that it removes odours from your room, not steam. o Warning - Always ensure that the cooker hood has been disconnected from the power supply before carrying out any work on the hood, including replacing light bulbs.
-
Page 8: Specifications Of Your Btc6740Ss Cooker Hood
Specifications of your BTC6740SS cooker hood Congratulations on purchasing a Baumatic cooker hood! PRODUCT DIMENSIONS Height: 480 mm – 860 mm Width: 600 mm Depth: 500 mm DIMENSIONS OF CHIMNEY SECTION: 276 mm x 303 mm Your stainless steel cooker hood is fitted with:... -
Page 9: Specifications Of Your Btc9740Ss Cooker Hood
Specifications of your BTC9740SS cooker hood Congratulations on purchasing a Baumatic cooker hood! PRODUCT DIMENSIONS Height: 480 mm – 860 mm Width: 900 mm Depth: 500 mm DIMENSIONS OF CHIMNEY SECTION: 276 mm x 303 mm Your stainless steel cooker hood is fitted with:... -
Page 10: Using Your Baumatic Cooker Hood
To use your cooker hood o Make sure that it has been installed by a suitably qualified person, as per the information contained in Baumatic’s installation instructions. o Find the control panel, which is located in the middle of the canopy. -
Page 11: Setting The Time Of Day
o Press the Light button to switch the bulbs on and off. You can switch the lights on, even if the hood is not operating. IMPORTANT: IDEALLY YOU SHOULD TURN ON YOUR HOOD TEN MINUTES BEFORE YOU START TO COOK, OR AT THE VERY LEAST WHEN YOU BEGIN COOKING YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING... -
Page 12: Cleaning Your Baumatic Cooker Hood
Cleaning your Baumatic cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT YOU HAVE SWITCHED YOUR COOKER HOOD OFF AT THE OMNI-POLAR SWITCH, SET AT THE WALL FROM THE CABL E. Cleaning o Clean the external parts of your cooker hood with mild liquid deter gent and a new damp cloth. -
Page 13: Maintenance
intenance Removing and cleaning the grease filters o First remove the grease filters by pulling down on the handle and pulling them away from the cooker hood. o Soak the grease filter in hot water and washing up liquid for about an hour. -
Page 14: Changing A Light Bulb
hanging a light bulb IMPORTANT: BE FORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FRO YOUR MAINS SUPPLY. o Remove the grease filter (as described on page 13). o Prior to touching the light bulbs ensure that they have cooled down. -
Page 15: Fitting The Carbon Filters
itting the carbon filters the appliance is being used to be used in recirculation mode then it is necessary to fit carbon filters. This will help to absorb unpleasant odours caused by cooking. IMPORTANT: BE FORE ATTEMPTING TO FIT OR REMOVE THE CARBON FILTERS, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED T COOKER HOOD FROM YOUR MAINS SUPPLY. -
Page 16: Installation
Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicate d on the rating plate are exactly the same as the voltage and frequency in your home. The rat plate can be found behind the grease filter. -
Page 17: Before Beginning Installation
o As the colours of the wires in the appliance’s mains lead may not correspond with the coloured markings identifying the t erminals in your spur box, please proceed as follows: o The blue wire must be connected to the terminal marked “N”... -
Page 18: Installing Your Cooker Hood
Do not tile, grout or silicone this appliance to the wall. This appliance is designed to b e surface mounted only. Ins a t lling your cooker hood IMPORTANT: YOU WILL HAVE TO DECIDE BEFORE INSTALLING YOUR COOKER HOOD WHETHER TO USE IT IN EXTRACTION MODE OR RECIRCULATION MODE. - Page 19 a) The support screw holes are indicated by figure A in this drawing nd the anchoring screw holes are indicated by figure B. ) Using a drill bit with a 8 mm iameter, make holes in the wall on the ositions that you have marked in step 4) Insert raw plugs into all of the holes that you have drilled.
- Page 20 ) Hang the hood onto the support crews. Fully tighten the support screws (A) and then screw the anchoring crews (B) through the relevant holes in the cooker hood. Tighten the anchoring screws fully into the wall...
-
Page 21: Connecting To External Ducting
onnecting to external ducting 8) Connect the coupling to the top of the cooker hood, and then connect a 125 mm ducting hose to the coupling (please note that the ducting hose is not supplied with the appliance). o The other end of the ducting hose should be connec ted to your discharge outlet that is suitable for cooking vapours. - Page 22 Lift chimney section D upwards until it reaches the ceiling. You ust ensure that it is perpendicular to the hood. o Mark the side measurement of both sides of chimney section D on the wall with a pencil and then remove c himney section D.
- Page 23 Using a 8 mm drill bit, drill out two holes on the pencil markings at you made in step 11. Insert raw plugs into the holes and then use screwdriver to secure the fixing bracket to the wall. o Refit chimney section C to the hood and fix it onto the hood using the two screws that are supplied.
-
Page 24: Completing The Installation
ompleting the installation If you are setting the appliance to re circulation mode, then you should ow fit the two carbon filters. See the “Fitting the carbon filters” section on page 15. The electrical connection must correspond to the electrical requirement noted on the rating plate, which is placed inside the cooker hood. -
Page 25: Troubleshooting
MPORTANT: If your cooker hood appears not to be operating roperly, before contacting the Baumatic Service Department, please refer to the c hecklist below. My cooker hood will not start. Check that the hood is connected to the electricity supply Check that the fan speed control is set correctly. - Page 26 Or any installation other han the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
-
Page 27: Contact Details
Czech Republic Baumatic CR spol s.r.o. mperova 495 6215, Librec zech Republic United Kingdom 420 800 185 263 Baumatic Ltd., Baumatic Buildings, www.baumatic.cz 6 Bennet Road, Reading, Berkshire Slovak Republ RG2 0QX Baumatic Slova kia, s.r.o. United Kingdom Skultetyho 1...
Need help?
Do you have a question about the BTC6740SS and is the answer not in the manual?
Questions and answers