Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Baumatic BTC6720
Summary of Contents for Baumatic BTC6720
- Page 1 BTC6720BL/BTC6720SS/ BTC6720W F60.2BL/F60.2SS Cooker Hood...
-
Page 2: Cooker Hood
User Manual for your Baumatic BTC6720BL/BTC6720SS/BTC6720W F60.2BL/F60.2SS Cooker Hood 60 cm Cooker Hood in black 60 cm Cooker Hood in stainless steel 60 cm Cooker Hood in white NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. -
Page 3: Table Of Contents
Contents Page Environmental note IMPORTANT SAFETY INFORMATION Specifications of your cooker hood Using your Baumatic cooker hood Before first use To use your cooker hood Cleaning your Baumatic cooker hood The grease filters Maintenance Removing and cleaning the grease filters... -
Page 4: Environmental Note
ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person. -
Page 5: Important Safety Information
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Technical Department. - Page 6 you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
- Page 7 removing air from your room. Ensure that proper ventilation measures are being observed. o Note that it removes odours from your room, not steam. o Warning - Always ensure that the cooker hood has been disconnected from the power supply before carrying out any work on the hood, including replacing light bulbs.
-
Page 8: Specifications Of Your Cooker Hood
Specifications of your cooker hood Congratulations on purchasing a Baumatic cooker hood! Your stainless steel cooker hood is fitted with: o High extraction tangential motor o Push button control operation o 3 Speeds o 2 Metallic grease filters o 2 lights... -
Page 9: Using Your Baumatic Cooker Hood
To use your cooker hood o Make sure that it has been installed by a suitably qualified person, as per the information contained in Baumatic’s installation instructions. o Find the control panel, which is located at the front right of the canopy. -
Page 10: Cleaning Your Baumatic Cooker Hood
OR AT THE VERY LEAST WHEN YOU BEGIN COOKING. YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING. Cleaning your Baumatic cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT YOU HAVE SWITCHED YOUR COOKER HOOD OFF AT THE OMNI-POLAR SWITCH, SET AT THE WALL FROM THE CABLE. -
Page 11: Maintenance
Maintenance Removing and cleaning the grease filters o Soak the grease filter in hot water and washing up liquid for about an hour. o Rinse them off thoroughly with hot water. o Repeat the process if required. o IMPORTANT: Let the grease filters dry thoroughly before refitting them in the cooker hood. -
Page 12: Changing A Light Bulb
IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY. o Prior to touching the light bulbs ensure they are cooled down. o Find the bulb that requires replacement, you will find it located in the light fixture which is inside the exposed section of the canopy. -
Page 13: Fitting The Carbon Filters
If the appliance is being used to be used in recirculation mode then it is necessary to fit carbon filters. This will help to absorb unpleasant odours caused by cooking. IMPORTANT: BEFORE ATTEMPTING TO FIT OR REMOVE THE CARBON FILTERS, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY. -
Page 14: Installation
Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated on the rating plate are exactly the same as the voltage and frequency in your home. The rating plate can be found behind the grease filter. -
Page 15: Before Beginning Installation
correspond with the coloured markings identifying the terminals in your spur box, please proceed as follows: o The blue wire must be connected to the o The brown wire must be connected to the Before beginning installation o Check that the product purchased is of a suitable size for the chosen installation area. -
Page 16: Installing Your Cooker Hood
appliance is designed to be surface mounted only. Installing your cooker hood IMPORTANT: YOU WILL HAVE TO DECIDE BEFORE INSTALLING YOUR COOKER HOOD WHETHER TO USE IT IN EXTRACTION MODE OR RECIRCULATION MODE. PLEASE TURN TO PAGE 22 NOW TO UNDERSTAND THE DIFFERENCES BETWEEN THESE TWO MODES. - Page 17 3) Using a drill bit with a 8 mm diameter, make holes in the wall on the positions that you have marked in step 4) Insert rawl plugs into all of the holes that you have drilled. 2a) The support screw holes are indicated by figure A in this drawing and the anchoring screw holes are...
- Page 18 ) Fully tighten the support screws (A) and then screw the anchoring screws (B) through the relevant holes in the cooker hood. Fully tighten the anchoring screws fully into the wall. 5) Fasten the support screws halfway in, leaving them 10 mm out of the wall.
-
Page 19: Connecting To External Ducting
8) Connect the coupling to the top of the cooker hood, and then connect a 125 mm ducting hose to the coupling (please note that the ducting hose is not supplied with the appliance). o The other end of the ducting hose should be connected to a discharge outlet that is suitable for cooking vapours have a cross section of at least 150 cm². - Page 20 Lift chimney section D upwards until it reaches the ceiling. You ust ensure that it is perpendicular to the hood. o Mark the side measurement of both sides of on the wall with a pencil and then remove chimney section D. 1) Take the fixing bracket (E) and place it between the two pencil arks that you made in step 9...
- Page 21 Using an 8 mm drill bit, drill out two holes on the pencil markings at you made in step 11. Insert raw plugs into the holes and then use screwdriver to secure the fixing bracket to the wall. o Refit chimney section C to the hood and fix it onto the hood using the two screws that are supplied.
-
Page 22: Completing The Installation
What is a charcoal filter and do I need one? ll cooker hoods have a grease filter but if you are using your cooker hood in recirculation mode, then a charcoal filter m ddition to the grease filter. -
Page 23: Troubleshooting
MPORTANT: If your cooker hood appears not to be operating properly, before con tacting the Baumatic Service Department, lease refer to the checklist below. My cooker hood will not start. o Ch ck that the hood is connected to th o Check that the fan speed control is set correctly. - Page 24 Or any installation other than the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
-
Page 25: Contact Details
United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berksh RG2 0QX United Kingdom Sales Tele phone (0118) 933 6900 ales Fax (0118) 931 0035 Service Telephon (0118) 933 6911 Service Fax (0118) 986 9124 Spares Telephone (01235) 4372... - Page 28 28 28...
Need help?
Do you have a question about the BTC6720 and is the answer not in the manual?
Questions and answers